Tugas Akhir
Material analysis of plate bending machine components in semi-automatic hydraulic systems / Galih Tri Ardhiyan
Abstrak
This research aims to analyze the material performance of components in a semi-automatic plate bending machine and evaluate the machine s efficiency and performance in bending metal plates with various thicknesses and bending angles. The primary focus of this research is the analysis of the machine components mdash jig frame table and banding bit mdash to assess their strength durability and stability during the bending process. This research uses a simulation-based numerical analysis method with a quantitative approach. Simulations were performed on the main components of a semi-automatic hydraulic plate bending machine using ANSYS Student Version software. The research stages included creating a 3D component model using Autodesk Inventor assigning material properties meshing applying a compressive force of 15 000 N and analyzing the results in terms of stress (Von Mises) total deformation and safety factor. Simulations were conducted to evaluate the machine s structural performance under working loads and compare the results with manual calculations based on basic engineering mechanics formulas. The simulation process was carried out using ANSYS Student Version software under static loading conditions and produced stress distribution data (von mises stress) total deformation and safety factor values. The simulation results showed that the maximum stress of the frame was 243.98 Mpa v die was 1.8416 Mpa while the punch was 2.2091 MPa below the yield limit of mild steel material of 250 MPa and the maximum deformation of the frame was 0.22331 mm v dies was 9.5279 mm while the punch was 0.00010931 mm and the safety factor value of the frame was 1.0247 v dies was 15 while the punch was 15 which indicated that the structure was very safe. Validation was carried out through analytical calculations using the bending stress formula so that the simulation accuracy was acceptable.