Tugas Akhir
The effect of print speed and nozzle temperature on the quality of polylactic acid (pla) filament-based products in fused deposition modeling (fdm) type 3d printing / Ahmad Fatih \'Athoillah
Abstrak
This study aims to analyze the effect of print speed and nozzle temperature variations on the quality of 3D-printed products made from Polylactic Acid (PLA) using the Fused Deposition Modeling (FDM) method. Three main aspects were examined including dimensional accuracy mass homogeneity and surface roughness with the goal of determining the optimal parameter combination that produces precise dense and high-quality prints. The research was conducted experimentally by printing block-shaped specimens with dimensions of 60 times 20 times 5 mm under nozzle temperature variations of 190 deg C 200 deg C 210 deg C and 220 deg C as well as print speeds of 100 mm/s 150 mm/s 200 mm/s and 250 mm/s. The tests included dimensional measurements using a digital caliper mass using a precision scale and surface roughness using a surface roughness tester. The collected data were analyzed descriptively to evaluate the significant influence of the printing parameters. The results indicate that both nozzle temperature and print speed significantly affect product quality. The optimal combination was found at a nozzle temperature of 200 deg C and a print speed of 200 mm/s where dimensional deviation was minimal specimen mass was more homogeneous and surface roughness was smoother. Excessive nozzle temperature led to over-extrusion while insufficient temperature caused under-extrusion. This study emphasizes the importance of optimizing printing parameters in the FDM process to produce PLA products with the best quality.