UPT Perpustakaan UM

  • Beranda
  • Informasi
  • Repository UM
  • SIPADU UM
  • OPAC SIPADU

Pencarian Spesifik

Pencarian berdasarkan :

SEMUA Pengarang Subjek ISBN/ISSN Pencarian Spesifik

Pencarian terakhir:

{{tmpObj[k].text}}
No image available for this title

Tugas Akhir

Analysis of bending results from variations in pipe thickness and pipe material in a semi-automatic multifunction bending machine / Fajar Arya Saputra

Saputra, Fajar Arya - Nama Orang;

Abstrak
The pipe bending process is a crucial aspect of the Indonesian manufacturing industry. To improve efficiency a semi-automatic pipe bending machine has been developed. The pipe forming process commonly referred to as pipe bending plays a crucial role in determining production quality and efficiency. This study aims to determine the effect of varying pipe thickness on the bending results after the bending process and the effect of varying pipe material on the bending results after the bending process. The research method used was experimental with data collected on the thickness and rolling results of the pipe material. Pipe bending tests were conducted using two types of pipe galvanized pipe and carbon steel pipe with a diameter of 19 mm and thicknesses of 1 mm 1.5 mm and 2 mm with a target angle of 90 ordm . The test results will be analyzed to determine the effect of varying thickness and material on the bending results. After the testing the data were analyzed to determine the effect of varying pipe thickness and material on the bending results. The results showed that the greater the initial pipe thickness the more stable the bending results. The highest thinning rate was 50% for 1 mm carbon steel while the lowest thinning rate was 6.66% for 2 mm galvanized steel. Galvanized pipes are more resistant to deformation than carbon steel pipes especially at thicknesses above 1.5 mm. This is supported by data showing that 2 mm galvanized pipes experienced only 6.66% thinning while 2 mm carbon steel experienced 33% thinning even though the strain for both was recorded at the same 7.07%.


Informasi Detail
DDC
TUGAS AKHIR DIGITAL
Prodi
Universitas Negeri Malang. Program Studi Teknologi Rekayasa Manufaktur, 2025.
Deskripsi Fisik
xvi, 62 hlm : ilus.
Bahasa
No Reg
0199/TA/25
Edisi
Tugas Akhir (Diploma) -- Universitas Negeri Malang. 2025
Subjek
Bending Machine, Pipe Thickness Variation, Pipe Material Variation
Pembimbing
1. Drs. Abdul Qolik, M.pd
Lampiran Berkas
You must be logged in to get fulltext


UPT Perpustakaan UM
  • Berita

Tentang Kami

TIM IT Perpustakaan 2023

Cari

masukkan satu atau lebih kata kunci dari judul, pengarang, atau subjek

Donasi untuk SLiMS

Pilih subjek yang menarik bagi Anda
  • Karya Umum
  • Filsafat
  • Agama
  • Ilmu-ilmu Sosial
  • Bahasa
  • Ilmu-ilmu Murni
  • Ilmu-ilmu Terapan
  • Kesenian, Hiburan, dan Olahraga
  • Kesusastraan
  • Geografi dan Sejarah
Icons made by Freepik from www.flaticon.com
Pencarian Spesifik